Hi all,
I am having a tough time with making ESYS working with ICOM NEXT A.
I had a hard time reading this car even with ENET, so left the car locked for a couple of hours while i was doing something else.
Returned back to car now, and ENET worked straight away.
ICOM NEXT A though even is reserved in itool , still ESYS says "no ZGW available".
i did pretty much everything i could find on the internet for this, but still no joy.
What am i missing?
P.S wireshark can see packets on lan with icom connected
(09-12-2020, 03:01 PM)DayvG Wrote: [ -> ] (09-12-2020, 01:57 PM)4evermetalhead Wrote: [ -> ]Hi all,
I am having a tough time with making ESYS working with ICOM NEXT A.
I had a hard time reading this car even with ENET, so left the car locked for a couple of hours while i was doing something else.
Returned back to car now, and ENET worked straight away.
ICOM NEXT A though even is reserved in itool , still ESYS says "no ZGW available".
i did pretty much everything i could find on the internet for this, but still no joy.
What am i missing?
P.S wireshark can see packets on lan with icom connected
That’s because the ICOM won’t see the ZGW/VIN readout in esys. You need to use iTool radar to read the ICOM IP address and enter it into the box in esys connection window that says ICOM/Ethernet. Keep the port the same, just put the IP where the 127.0.0.1 is.
Thanks for the reply mate.
Yes, correct. I managed to figure it out.
Though now i am facing another issue.
I get this:
No FP could be generated from FA "". [C002]
Not all elements of the FA were found in the FA2FP: HO-Word FLCN
[72]
when activating FA.
Refers to headlight sensitivity, which i know has been changed before to 100%, though i dont know if that causes the error or not.
I am now downloading PSzData 4.25.12, hoping this will help.
Though i think this is unrelated to the issue.
Whatever is causing the issue must be removed from the FA, it’s not compatible hence the problem. If you remove the code at fault and calculate FP It will work. Basically remove FLCN
Feel free to message me mate, I can look remotely for you and check everything is ok.