Bimmer Scene - Latest BMW Coding / Retrofits / Maps

Hello, 

Hope all is well  

So after many issues installing E-Sys and getting it working, I can finally get on with some coding!

First snag however. I am trying to change the start up for the headunit to an M-Sport Emblem.

As per the guides included, I connected to ESYS via ENET cable, and followed the steps through to changing the code.

Located 3001 parameter, and need to change the parameter to Variant 01 as per instructions:

Change i-Drive Animation to ///M Logo

3001 -STARTUP_EMBLEM set to: variant_01

But the option to 'Edit' the Variant_01 is greyed out (see attached picture) meaning I cannot edit the field.

Any ideas?

Thanks in advance!

Hello Tim,

You need to run E-sys via Launcher Pro.
So first run LP, and start E-Sys 3.30 from it.

(11-20-2020, 08:51 PM)Alec01 Wrote: [ -> ]Hello Tim,

You need to run E-sys via Launcher Pro.
So first run LP, and start E-Sys 3.30 from it.

Hi Alec,

I ran this via Launcher Pro, no errors etc.....showing supported by token master at the top of the screen etc.

Unavailable to edit though when I right click.

Picture attached

You don't edit the right point. You must edit read out value.

(11-21-2020, 06:46 PM)svenson Wrote: [ -> ]You don't edit the right point. You must edit read out value.

Thank you! Will take a look at it again

(11-21-2020, 06:46 PM)svenson Wrote: [ -> ]You don't edit the right point. You must edit read out value.

Hi    

Hope you are well.

Please see attached video, trying to see where I am going wrong!!!

Thanks for your help guys

Tim

Hi Tim,

Just go to the last folder augelesen, and change the value there.

P.S: if you like to change also the default drive mode (FesPiaDefaultLastUserMode) when turning on the engine, let me know. It needs to be done on bdc_body ecu.

(11-27-2020, 06:00 PM)Alec01 Wrote: [ -> ]Hi Tim,

Just go to the last folder augelesen, and change the value there.

P.S: if you like to change also the default drive mode (FesPiaDefaultLastUserMode) when turning on the engine, let me know. It needs to be done on bdc_body ecu.

Hi Alec, 


Thanks for such a quick reply! I will check that last folder. I definitely want to change the default drive mode to Sport when turning on the engine, that was my next project! 

Thank you very much