|
|
|
| BMWHoochie's Most Thanked Post |
| Post Subject |
Numbers of Thanks |
| RE: ISTA Standalone / SQLiteDBs / SDP / BLP - latest |
1 |
|
|
| Post Message |
(01-19-2021, 09:55 PM)XuLeTZ Wrote: (01-19-2021, 07:23 PM)BMWHoochie Wrote: Just wanted to update anyone having problems using the USB K+DCAN K+CAN. Follow the below instructions
1. Plug your K+D-CAN cable and install drivers. For FTDI based cables use latest drivers.
2. Open “Device Manager”, then USB Serial Port properties, go to “Port Settings” tab and click
“Advanced...”. Change port number to “COM1” and latency timer to “1”. Confirm configuration
via “OK” button.
3. Open C:\EDIABAS\BIN\EDIABAS.INI with Notepad and check for “Interface = REMOTE and change to STD:OBD”.
4. In TCP settings confirm “Port = 6801”.
5. Close EDIABAS.INI Open ISTA and Select “VCI Config” tab and select “Ediabas standard settings (ediabas.ini)”, then “OK”.
That is what I did, and everything is working perfectly. My COM was set to COM9. It needs to be changed to work correctly.
Appreciate the files! Thanks for info, but ISTA doesn`t use the EDIABAS from C:/ drive.It has it's own ediabas configuration which is in Rheingold\Ediabas
Glad it worked for you that way. Usually i`m changing the settings from Settings > Vehicle interface when I`m plugging in the K+D-Can cable You are correct. Was thinking about my previous installation, and not this new install lol. I will update that in my post. Appreciate the correction. |
|
