NBT EVO Bench setup - Printable Version +- Bimmer Scene - Latest BMW Coding / Retrofits / Maps (https://www.bimmerscene.com) +-- Forum: Bimmer Scene Coding & Navigation (https://www.bimmerscene.com/forumdisplay.php?fid=1) +--- Forum: BMW F / G Series Coding & Retrofits & Diagnostics (https://www.bimmerscene.com/forumdisplay.php?fid=3) +--- Thread: NBT EVO Bench setup (/showthread.php?tid=2613) |
NBT EVO Bench setup - alsamaraie - 04-16-2022 Hi, I need help/information on how to make NBT EVO from a G30 turn the screen on on bench. I'm connecting as flow: A ZGW2-4sk to HU via k-can2 HU connected to CID screen also connected ZBE3 (touch). I reflashed the ZGW with same vin as HU. ZGW connected to enet cable. I can see and code HU in esys. I can see and diagnos HU and ZGW in ista. But the screen still black. Can not see the ZBE3 (touch) on esys and It does not light. I could run the R,G,B test on the screen in ista and the screen works fine. I use an Arduino CAN bus code to wakeup the HU and the ZGW. Can see on ampere meter when they went wake and sleep. Otherwise I would not be able to communicate with them via esys vs ista. I tried to connect the What I am missing here? These are the commands I used. I tried other commands but same result. the HU and ZGW are wake but screen still black. Using these two commands every 500 ms. < message1.can_id = 0x130; //formatted in HEX message1.can_dlc = 5; //formatted in DEC message1.data[0] = 0x45; message1.data[1] = 0x40; message1.data[2] = 0x22; //formatted in HEX message1.data[3] = 0x8F; message1.data[4] = 0xFE; message2.can_id = 0x12F; //formatted in HEX message2.can_dlc = 8; //formatted in DEC message2.data[0] = 0x37; message2.data[1] = 0x7C; message2.data[2] = 0x8A; message2.data[3] = 0xDD; //formatted in HEX message2.data[4] = 0xD4; message2.data[5] = 0x05; message2.data[6] = 0x33; message2.data[7] = 0x06; > RE: NBT EVO Bench setup - HootisTigglebits - 02-22-2023 Did you ever get this working? |