NBT Retrofit E90 LCI - Printable Version +- Bimmer Scene - Latest BMW Coding / Retrofits / Maps (https://www.bimmerscene.com) +-- Forum: Bimmer Scene Coding & Navigation (https://www.bimmerscene.com/forumdisplay.php?fid=1) +--- Forum: BMW E Series Coding & Retrofits & Diagnostics (https://www.bimmerscene.com/forumdisplay.php?fid=2) +--- Thread: NBT Retrofit E90 LCI (/showthread.php?tid=4834) |
NBT Retrofit E90 LCI - Nighteagle_67 - 12-02-2022 Hi guys maybe one of you has more experience. I have here a used NBT emulator from the company Bimmerretrofit. As far as I know, you have to activate it, because the emulator can always be keyed to one VIN at a time. However, the NBT works even without activation so far that it starts and is operable. Now I have the following problem: I cannot establish a connection with E-SYS. My vehicle is an E90 LCI and should already have the ENET pin in the OBD socket. As static IP address I use 169.254.199.90 and connect via E-Sys via Gateway. However, when I then read out via ECU in Esys, the NBT does not show up. Can this be because it is not activated? Furthermore, I can not connect to the emulator via micro USB. It may well be that the previous owner has damaged the port, but as far as I know that is not a big deal, except that I can not do firmware updates. The activation should also work via the iDrive. Again, another problem: when I'm in iClick mode, the minute hands only go to 15 and no further. Maybe someone has this conversion behind him and can help me. Best Regards! RE: NBT Retrofit E90 LCI - Nighteagle_67 - 12-03-2022 Ok Guys.. i have found the fault. the wire was not perfectly on and the right ip adress is not 169.254.199.90. the right one is 169.254.199.99. fyi if someone has the same troubles |