+- Bimmer Scene - Latest BMW Coding / Retrofits / Maps (https://www.bimmerscene.com)
+-- Forum: Bimmer Scene Coding & Navigation (https://www.bimmerscene.com/forumdisplay.php?fid=1)
+--- Forum: BMW F / G Series Coding & Retrofits & Diagnostics (https://www.bimmerscene.com/forumdisplay.php?fid=3)
+--- Thread: 2014 F10 VO code and inject CAFD Bimmer Utility (/showthread.php?tid=5444)
2014 F10 VO code and inject CAFD Bimmer Utility - dcummins41 - 06-13-2023
I just purchased Bimmer Utility(Windows Version) last week.
They e-mailed me back and said.
"Hello, yes it can VO code the new module and inject the cafd if needed"
Anyways, I changed out the RDC module as the old one was dead. I confirmed in ÎŜ†Ä+
*Note* This is a used module off E-bay, same part#.
So, how do I do this using Bimmer Utility to vo code or inject CAFD file if needed?(I'm using Windows Version)
I'm also confused on why new ė-šÝ§ I downloaded, says use with Bimmer Utility? I downloaded and it runs by itself.
Thanks,
Duane, MI
RE: 2014 F10 VO code and inject CAFD Bimmer Utility - adelin731 - 06-13-2023
(06-13-2023, 04:02 AM)dcummins41 Wrote: I just purchased Bimmer Utility(Windows Version) last week.Install the new module
They e-mailed me back and said.
"Hello, yes it can VO code the new module and inject the cafd if needed"
Anyways, I changed out the RDC module as the old one was dead. I confirmed in ÎŜ†Ä+
*Note* This is a used module off E-bay, same part#.
So, how do I do this using Bimmer Utility to vo code or inject CAFD file if needed?(I'm using Windows Version)
I'm also confused on why new ė-šÝ§ I downloaded, says use with Bimmer Utility? I downloaded and it runs by itself.
Thanks,
Duane, MI
open bimmerutility and connect the car
click on the 3 dots next to the module and inject cafd or whatever it says in there
then click on the 3 dots again and vo code
job done.
RE: 2014 F10 VO code and inject CAFD Bimmer Utility - mauro - 09-06-2024
Hi Adelin, I have the same problem as Duane. However, I can't find any way to inject the new CAFD from BU (when clicking on the three dots, there is no option). Are you sure? Can you give me more specific instructions?