02-26-2026, 08:31 AM
Hello everyone,
Thanks to you and your very usefull posts i managed to install the BMW software kit ( ISTA 4.56.30 with PSDZdata 4.57.30 and all the StandardTools with EDIABAS 7.6.0 ) . I haven't received any errors when installing the kits and the antivirus hasn't reported anything to catch my attention.
The problem is that when i try to connect to my E46 320d and to a friend's E60 525d the software can identify the vehicle with VIN number and everything but when it comes to doing a scan it won't identify any of the ECU's, they show up on the tree list but i can't comunicate with them. I'm trying to use a genuine ICOM Next interface on it, and it detects both permanent 12V and ignition 12V lines . I attached all the info that i think they might give you an idea about the origins of my problem.
Any suggestions are welcomed.
Thank you!
Thanks to you and your very usefull posts i managed to install the BMW software kit ( ISTA 4.56.30 with PSDZdata 4.57.30 and all the StandardTools with EDIABAS 7.6.0 ) . I haven't received any errors when installing the kits and the antivirus hasn't reported anything to catch my attention.
The problem is that when i try to connect to my E46 320d and to a friend's E60 525d the software can identify the vehicle with VIN number and everything but when it comes to doing a scan it won't identify any of the ECU's, they show up on the tree list but i can't comunicate with them. I'm trying to use a genuine ICOM Next interface on it, and it detects both permanent 12V and ignition 12V lines . I attached all the info that i think they might give you an idea about the origins of my problem.
Any suggestions are welcomed.
Thank you!
![[-]](https://www.bimmerscene.com/images/collapse.png)