We have recieved 83% of our goal ..


Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
520D E60 2007 modules stuck in Programming Mode 12
#1
Hi, guys.

Somehow I screwed up my MMI/CCC and Bluetooth modules in my car.

The modules have the following ZB numbers:

MMI/CCC - 9176841
VIRTSG91 - 9176842

I couldn't find anywhere those ZB numbers.

I managed to re-write the CCC with a different ZB (I have an ICOM cable and some knowledge to use the MOST connection) but although the audio is working fine I can't see any words on the screen. Also, the BlueTooth (VIRTSG91) is still in programming mode as I couldn't find the ZB mentioned above. 

Also I have a permanent error after I replaced the ECU (which I fried accidentally) called 2E3C DDE: EWS Anti-tampering Manipulation. Which means the CAS and the ECU needs to be synchronized, is just I couldn't find anywhere how to do that.

Any advice would be much appreciated.

Thanks
Reply
#2
Post a screenshot from ista of ecu tree page. And dme can be synced though ista too in service functions
Reply
#3
For some reason I couldn't sync them in ISTA+ or ISTA-P.

In the end I was able to sort out the two modules I had stuck in programming mode 12, actually ISTA-P detected them and recoded and reprogram them both, so now they are working absolutely fine. The only issue I have left is syncing the DME with the EWS, which I couldn't do so far.
Reply




Users browsing this thread: 1 Guest(s)