We have recieved 83% of our goal ..


Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Coding ECU
#1
Hello everyone!

I'm new to coding here, but I have been reading quite a lot lately about this topic. 

The problem is this, I just started coding yesterday and wanted to add SPORT+ to my F10 520d.

The thing is, I read that I just have to slightly modify my FA - to remove 205 and add 2TB. I did just that, but the problem is I applied it to all the ECU's, not only the ones that I had to (EGS, ICM, & KOMBI). Unfortunately, I didn't save a copy of the original FA (with the 205, without the 2TB), so I was wondering, are there gonna be any issues since I applied 2TB to every ECU?

And while we're at it, if I modify the FA again by removing 2TB and adding 205, will my FA be the same as the original or will there be issues of some kind?
Reply
#2
2TB only applies to EGS, ICM, KOMBI so other modules the coding would remain the same. If you edit back 205 and remove 2TB you would have original FA.
[-] The following 1 user says Thank You to TheNine90 for this post:
  • adelin731
Reply




Users browsing this thread: 1 Guest(s)