We have recieved 83% of our goal ..


Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
3AG F10 Reversing Camera
#1
Hi guys, its probably straight forward but always good to have a wiring diagram.

Anyone have one for retrofitting reversing camera to f10?

have the module, wiring, camera and handle here.


Many Thanks
Reply
#2
In Case someone was looking so far i Know:

Switch mounted in the boot, Power wire goes to rear fuse box socket F121 in ZW2*10B
If you bought a harness its a green wire

From switch to camera you have video cable with grounding point along the way.

From switch to front of car you have one ground cable on the main loom,
The 3 pins go to quadlock
- Yellow - pin 21,
- White - pin 24
- Shield (clear) to pin 23

Orange and light green are can wires that go to same colour wires in IHKA connector

Finally, add 3GA to FA and code NBT and PDC.

Also, might need to run ista and calibrate camera.

Ill be doing this on tuesday will follow up.
Reply
#3
All went smooth, pretty simple just time consuming.

https://www.facebook.com/MCODINGIRELAND/...0781209526
Reply




Users browsing this thread: 1 Guest(s)