Dear brothers, I need help. G05_X5_30d_hybrid

[supermen892]

This is a G05_X5_30d_hybrid vehicle. I encountered a problem while working on a set of 3 crystal gear knobs. I disconnected the trunk battery of the hybrid vehicle, but the power did not go out, so I replaced the gear knob while the power was on. After that, I cannot drive with a message saying that the P button cannot be used. Fault code content: There are three codes: 802683, 802694, and 802692. They say that the faulty codes of 802694 and 502692 can be eliminated by replacing the defective chip, but will the code of 802683 (replacing the selector lever handle without disconnecting the battery) also disappear after replacing the chip?

[TheNine90]

The error will still be there since it cannot be erased. You can try reflashing the firmware and check if it can reset