+- Bimmer Scene - Latest BMW Coding / Retrofits / Maps (https://www.bimmerscene.com)
+-- Forum: Bimmer Scene Meet (https://www.bimmerscene.com/forumdisplay.php?fid=5)
+--- Forum: Request Section (https://www.bimmerscene.com/forumdisplay.php?fid=22)
+--- Thread: NBT EVO dead (/showthread.php?tid=2757)
NBT EVO dead - Pedrom92 - 06-08-2022
Hello, I have nbt Evo id5/6 with blue connector from the factory but I was using the GPS through the ATM, it always worked well from a while ago I stopped giving the GPS and lost the online services, I flashed again it was the same it was going to flash with an older version and it never worked again, I only have the fan turned on at maximum and not even on esys detect.
is there any solution?
I have an ID4 for parts, will it be possible to leverage something for the ID5?
if I put the lower board on ID5 I can already see it on esys but the HWEL is different as it should be and I can't flash through OABR/ethernet only through UDS.
Thanks
RE: NBT EVO dead - Rob - 06-09-2022
Hello,
does it ping?
RE: NBT EVO dead - Pedrom92 - 06-09-2022
Hello,
I haven't tried to see if it pings yet. I think the problem is in the V850 if I use a board where the V850 of another Evo is I managed to flash and reset all the SWFL but when I put mine the fan works normally but esys does not see and the screen says NO SIGNAL.
Only this is an Evo with original blue connector and it's not easy to get one like it to make a backup of the V850.
I have VVDIprog, I just need Evo!
I'm probably saying bullshit, nbt hardware is very new to me.
Thanks