BMW ISTA-D 4.49.41 Standalone Activated - Torrent/Mega

[Simao]

Thanks for sharing!

[subway47]

READ CAREFULLY!!!

THIS IS NOT AN INSTALLER!

EXTRACT AND PUT ALL THE NECESSARY FILES INTO THE MAIN RHEINGOLD FOLDER SUCH AS SQLITEDBS AND BLP FILE.

YOU SHOULD KNOW WHERE THEY GO BY NOW IF YOU ARE DOWNLOADING THIS.

RENAME THE RHEINGOLD FOLDER TO ISTA AND PUT IN IN C:/EC-APPS/

RUN THE REG FILE AND FIRE UP ISTA-D 4.49.41

You have not unlocked this post's content yet. Please reply to this thread to unlock the content.

Thanks and best regards

---

READ CAREFULLY!!!

THIS IS NOT AN INSTALLER!

EXTRACT AND PUT ALL THE NECESSARY FILES INTO THE MAIN RHEINGOLD FOLDER SUCH AS SQLITEDBS AND BLP FILE.

YOU SHOULD KNOW WHERE THEY GO BY NOW IF YOU ARE DOWNLOADING THIS.

RENAME THE RHEINGOLD FOLDER TO ISTA AND PUT IN IN C:/EC-APPS/

RUN THE REG FILE AND FIRE UP ISTA-D 4.49.41

You have not unlocked this post's content yet. Please reply to this thread to unlock the content.

Thanks and best regards

[zk1974]

Thank you very much

[nieshdani1568@gmail.com]

SORGFÄLTIG LESEN!!!

DIES IST KEIN INSTALLATIONSPROGRAMM!

EXTRAHIEREN SIE ALLE NOTWENDIGEN DATEIEN, WIE SQLITEDBS UND BLP-DATEIEN, UND LEGEN SIE SIE IN DEN HAUPTORDNER RHEINGOLD

. SIE SOLLTEN JETZT WISSEN, WO SIE HINKOMMEN, WENN SIE DIES HERUNTERLADEN.

BENENNEN SIE DEN ORDNER RHEINGOLD IN ISTA UM UND LEGEN SIE IHN IN C:/EC-APPS/.

FÜHREN SIE DIE REG-DATEI AUS UND STARTEN SIE ISTA-D 4.49.41

You have not unlocked this post's content yet. Please reply to this thread to unlock the content.

Danke

[see_you_33]

thank you very much

appreciate it

[dzooky]

Thank you very much bro

[smoke100]

any one need help with this when i start ISTA


log4net:ERROR Failed to find configuration section 'log4net' in the application's .config file. Check your .config file for the <log4net> and <configSections> elements. The configuration section should look like: <section name="log4net" type="log4net.Config.Log4NetConfigurationSectionHandler,log4net" />

[sinnerman]

THANK YOU VERY MUCH!

[Maccydee91]

Thanks for your time and effort!

[Hotsd101]

tested and confirmed it works with some possible bugs.

1. with icom after clearing fault codes, when ignition is turned back on, it does not rescan automatically
2. when you manually scan after that, it freezes for some time before commencing
3. does not support toyota supra, can it be added in config ?
4. it does dont have information search anymore ? did bmw remove this feature without being connected to vehicle
5. when switching between esys or standard tools c:/ediabas/bin must we changed if you want to use easy connect with icom or cables. so ista has its own bin folder which only works for ista. esys/standard tools has a different one. in 4.32 i think it was, same one for all was fine.

Thanks for sharing