TUT! Alpina EGS Flash 530d F10/F11 (Mono Turbo Japan Version)

[BimmerMP]

Because I dont see any tutorials of flashing the Mono Turbo Version of Alpina EGS Software (all the Tutorials show the 535d Bi-Turbo Version), here is a Tutorial:

Go to Options---> Settings---> Options and deselect:
Update VCM after Tal execution
Update MSM after Tal execution

Connect your car to Esys:
Read VO, Save it "FA_(model)_Alpina"
Now Press on Edit

VO:
-Typeschlüssel: XA52 (nonLCI) or 5D12 (LCI)
-ZK: 07/12 - 0313 (nonLCI) or 0713 - newer (LCI)

Salapa:
920,9XA,807

Apply Changes, Calculate FP and if you dont get any errors you are good to go, click save on the Floppy Disk Icon.
Go one step back with the arrow icon (cklick "Yes" if something comes up)

Now on TAL-Calculation:
SVT Actual:
-READ ECU

SVT Target:
Set the "I-Step (shipm.):" to match the Zeitkriterium (ZK) you used on the FA(VO)!
leave the "I-Step (target): as it is!
now click on Calculate

After the Calculation you should see unter EGS:
"SWFL_00001C5E_XXX_XXX_XXX" in red, this meand you made the correct calculation and it will be flashed to this version (Alpina, Japan Mono Turbo Version)
(check if HWEL is Black!! If it is RED YOU HAVE TO CLICK ON "HW-IDs from SVTactual" now if HWEL is black after this step you can continue otherwise the flash will not work)

On SVT Update:
Click Save, save it as "SVT_SOLL"

Now under TAL:

Press "TAL calculation", press save and save it as "SVT_TAL"

Go to Expert Mode --> TAL_Processing:
Now on 
TAL: you have to load the "SVT_TAL" file you saved in the previous step
SVT Target: dont load any file just leave it blank
FA: click on "Read FA VCM)

Deselect All, just choose EGS: bFlash, swDeploy, cdDeploy (in some cases ther will be only swDeploy and cdDeploy to choose thats OK)

Now click on "Check software avalability" it should say "All software units (SWE) are availiable. [G062]

Now you can press on "Start" after the flash process is seccessfully done you have to go to Ista and clear all foult codes.

If these tutorial helped you, I would be happy if you like this thread and reply to it!

[bmwfan2024]

Hi,

I have a 2015 f07 530D GT LCI , will these settings work for my car?

Thanks

[spacepl]

Hi,
What is the difference between 535d Bi-Turbo Version and 530d single turbo versions in Alpina software?
I am with F07 530D GT pre LCI.

[bmwfan2024]

I tried it, but could not calculate the FA with the type settings in the post. Error: Not all elements of the FA were found in the FA2FP. Type code FD12. Tried other type codes same thing.

[spacepl]

Same to me. Also with F07 530D. Looks like some of FA options of F07 are not supported in alpina type code XA52. Maybe deleting them one by one will do the job.

[spacepl]

The EGS Alpina software for F10 is same as for the F07, right?
Strange, i made it with XA52 type code, it is flashed end drives ok, but here it is shown as Euro, not Japan.