Problem with the 2VB coding

[bravodoodle]

StonieG30 pid='68713' dateline='1674177334']The G30 in Thailand has the receiver hardware, but not the 2VO option, and also not the TPMS sensors.

I have coded everything again and now it is working. Seems like during the first coding not all modules were correctly coded.

Hi mate, I am trying to add TPMS sensors to '17 540i here in Australia. I believe our G30s come ready with RDC hardware but without TPMS sensors. I certainly had to get 433Mhz Autel TPMS sensors in a couple of months back. So yesterday I coded 2VB in using E-SYS and tried to detect the TPMS sensors, which are not getting detected.

So now the iDrive is throwing a tyre pressure warning on startup and in my dash. Since the TPMS sensors are installed in the car, it is very difficult to initiate them again without removing the wheel and tyre off. The phone does not pick up NFC signal in the sensor.

In your post above, you mentioned coding "2VO", whereas I read the option is 2VB, which one is correct ?