G07 Programing issues HELP please.

[Bimmerhead33]

I was attempting to encode a new A/C module I troubleshot for my 2020 X7 while I was in there I was updating the entire car as I no longer live near a dealership (closest is 7 hrs away). While I was updating shit went south and the programming halted and bricked the car. I’ve tried a lot but I can barely connect toy the car, ISTA+ will not complete a vehicle test anymore so it will not allow me to reattempt a program. Attached is the module tree as it looks now. Kinda last ditch at this point. I tried Esys but I think it was too late and the damage was done.

I’m willing to let someone remote it to help.

I'm sorry to hear man. Hopefully there is someone here that can help with this. From my past experience, when this happens at the dealer, there is a remote coding session (IWRAP) that attempts to renew firmware in the idividual modules that could not complete programming and to get the rest of the car communicating again. You may need to tow it to a dealer to have them do this if no one chimes in and can give you a direction/ can help you remotely code.

Did you have a high amperage charger attatched? 70+amp vehicle charger is always recommended for complete programming sessions in order to not loose communication between modules during full programming through ISTA+.

I wish I could help.