SDARS module not active B7F8DC

[wesleyredhat]

Hi Alec01, do you think that instead of trying to deactivate, i set it to active, the error can disappear?
I could set ti active all the inputs in headunit and trying to activate in tool32. I will post results

Hi Aspame82,

So I did multiple tries, with Shawn guidance, but I finally couldn't achieve to erase this SDARS fault.
I first tried with tool32 ("nbtevo.prg" for "steuern_routine "with "ARG;SDARS_ACTIVATION;EIN"), but was receiving a job status: ERROR_ECU_CONDITIONS_NOT_CORRECT

Then I tried with E-Sys ("External Applications"), but it was also not successfull (receving a "NO RESPONSE TO PHYS REQUEST" message).

If you like, I can send you the exact steps in E-sys, so you can give it a try. It might work at your end...
Just let me know.

hi, could you send me the procedure via e-sys?