08-16-2023, 04:59 PM
Ive been getting drive train malfunction intermittently when powering on my 328i.
Ive had to power it off and on 3-5 times until the error goes away and turbo works, until I power off the vehicle.
Upon scanning, it seems the error code says wastegate actuator soleonoid.
I know it works, maybe it has to be coded as the engine has been replaced on this vehicle?
How can I code the ECM to recognize the parts and work without triggering engine light or drive train malfunction?
Ive tried resetting all the codes and hoping it relearns, but that temporary solves it and ends up error again shortly.
I'm worried there's a short somewhere, or is it just needing coding? What software hardware do I need?
\
I got the Bimmergeeks standard tools package, along with E-SYS. How can I write the code on the ECU? What files do I need? Can I get the ethernet to OBD or USB to OBD cable to get it sent through? Thanks in Advance. h
Ive had to power it off and on 3-5 times until the error goes away and turbo works, until I power off the vehicle.
Upon scanning, it seems the error code says wastegate actuator soleonoid.
I know it works, maybe it has to be coded as the engine has been replaced on this vehicle?
How can I code the ECM to recognize the parts and work without triggering engine light or drive train malfunction?
Ive tried resetting all the codes and hoping it relearns, but that temporary solves it and ends up error again shortly.
I'm worried there's a short somewhere, or is it just needing coding? What software hardware do I need?
\
I got the Bimmergeeks standard tools package, along with E-SYS. How can I write the code on the ECU? What files do I need? Can I get the ethernet to OBD or USB to OBD cable to get it sent through? Thanks in Advance. h
![[-]](https://www.bimmerscene.com/images/collapse.png)