08-31-2020, 04:45 PM
Used ISTA+ to get some additional info and try to code that way
The FLER ECU shows up as blue - "programming abort" - in the map
There is a fault for "Programming abort detected." I'm assuming this was someone else, but it could have been me. I'm not sure what exactly a programming abort is, but it must cause an UNKN HWEL to be assigned to the device?
I tried to do a flash with ISTA+, but the process wont' start because it states that a hardware replacement is required. Presumably, this is the same "hwDeinstall" and "hwInstall" issue I saw when trying to run a TAL in ESys.
What else can I try to get this FLE back up and working? Will ISTA/P do anything different for me if I can get that running?
The FLER ECU shows up as blue - "programming abort" - in the map
There is a fault for "Programming abort detected." I'm assuming this was someone else, but it could have been me. I'm not sure what exactly a programming abort is, but it must cause an UNKN HWEL to be assigned to the device?
I tried to do a flash with ISTA+, but the process wont' start because it states that a hardware replacement is required. Presumably, this is the same "hwDeinstall" and "hwInstall" issue I saw when trying to run a TAL in ESys.
What else can I try to get this FLE back up and working? Will ISTA/P do anything different for me if I can get that running?
![[-]](https://www.bimmerscene.com/images/collapse.png)