Easy BMW Tools for E Series (NCS EXPERT,INPA,EDIABAS,WINKFP,TOOL 32,NCS DUMMY)

[m4ever]

To keep enjoying your privileges, Please always read the Forum's Updated Rules:  CLICK HERE

-------------------------------------------------------

What's Installed?
- Inpa 5.0.6 (with English script files & Support for F-series)
- EDIABAS 7.3.0
- NCS Expert (with English menus and buttons, and NCS Dummy Profile pre-installed)
- NCS Dummy 4.0.1
- Tool32 4.0.3
- WinKFP 5.3.1
- Integrated SP-DATEN v53.3
- BMW Coding Tool v2.5.0 (for use as an alternative to NCS Dummy, or to update DATEN files as new ones become available)
- USB Drivers for cable
Why is this Beneficial?
- One single installation will install ALL the programs needed for coding & diagnosis, will update the programs to show English menus, will set up NCSExpert with the correct NCSDummy profile, will automatically install USB Drivers, and comes integrated with SP-DATEN 53.3 (YES, Integrated!)
- All the latest versions of the programs in one neat install file
- No hunting or searching for SP-DATENs then struggling to import them
- SMALL file size. The entire package is only 170MB!! No need to download 15GB of DATEN files.

You have not unlocked this post's content yet. Please reply to this thread to unlock the content.

Thanks a lot

---

Thanks a lot

[Grot110]

Thx

[xednx]

Thank you. Been losing my mind with german fault codes

[ChrisRallye]

Thanks 

[hansw0rst]

Thank you again.

[Johnny79]

Thanks!!!

[Sbie7]

Thanks!!!

[Ishida95]

thanks

[allroundbmwcenter]

thanks

[Richard H]

Thank you