02-21-2022, 07:15 PM
okay I downloaded psdzdata 4.33.31 full deleted the old psdz lite out of c:\data and installed 4.33.31 full in its place. I did the:
Connect => Read FA (VO) => Activate FA (VO) => Read SVT (VCM) => Left-Click on desired ECU => Click on "Detect CAF for SWE" => Select the CAFD from latest I-Level shown => Select OK => Right-Click on ECU (the ECU itself not the underlying CAFD) => Select CODE.
That went fine as I hadn't deleted 524 from FA so when I detected caf for SWE it but the Adaptive headlight failure back so I coded that to OHne on lwr_ahl_type and FLC_Aktiv to nich_aktiv then coded that FDL and the cafd was green. Went over to ISta connected read all faults then cleared them all, then went into service mgmt functions CU list drilled into Body then Lighting had a red ABL so I went through the process said both left and right didn't need to be initialized then it asked if i wanted to adapt the LED's I said yes did both left and right told me to turn lights off and on which I did and I saw it go through the reference procedure I think it was called. I could see and hear it controlling the lghts interestingly it lights the turn signal corners up in the process on both sides.. But still no bueno on turn signals I am thinking there is another setting in FRM to make this work because the one light worked no problem for weeks until I tried to update the software to correct this issue
Connect => Read FA (VO) => Activate FA (VO) => Read SVT (VCM) => Left-Click on desired ECU => Click on "Detect CAF for SWE" => Select the CAFD from latest I-Level shown => Select OK => Right-Click on ECU (the ECU itself not the underlying CAFD) => Select CODE.
That went fine as I hadn't deleted 524 from FA so when I detected caf for SWE it but the Adaptive headlight failure back so I coded that to OHne on lwr_ahl_type and FLC_Aktiv to nich_aktiv then coded that FDL and the cafd was green. Went over to ISta connected read all faults then cleared them all, then went into service mgmt functions CU list drilled into Body then Lighting had a red ABL so I went through the process said both left and right didn't need to be initialized then it asked if i wanted to adapt the LED's I said yes did both left and right told me to turn lights off and on which I did and I saw it go through the reference procedure I think it was called. I could see and hear it controlling the lghts interestingly it lights the turn signal corners up in the process on both sides.. But still no bueno on turn signals I am thinking there is another setting in FRM to make this work because the one light worked no problem for weeks until I tried to update the software to correct this issue
![[-]](https://www.bimmerscene.com/images/collapse.png)