01-19-2021, 07:23 PM
(This post was last modified: 01-20-2021, 08:20 PM by BMWHoochie.)
Just wanted to update anyone having problems using the USB K+DCAN K+CAN. Follow the below instructions
1. Plug your K+D-CAN cable and install drivers. For FTDI based cables use latest drivers.
2. Open “Device Manager”, then USB Serial Port properties, go to “Port Settings” tab and click
“Advanced...”. Change port number to “COM1” and latency timer to “1”. Confirm configuration
via “OK” button.
3. Open C:\RHEINGOLD\EDIABAS\BIN\EDIABAS.INI with Notepad and check for “Interface = REMOTE and change to STD:OBD”.
4. In TCP settings confirm “Port = 6801”.
5. Close EDIABAS.INI Open ISTA and go to “Settings > Vehicle interface” and select “Ediabas default settings (ediabas.ini)”, then “OK”.
That is what I did, and everything is working perfectly. My COM was set to COM9. It needs to be changed to work correctly.
Appreciate the files!
1. Plug your K+D-CAN cable and install drivers. For FTDI based cables use latest drivers.
2. Open “Device Manager”, then USB Serial Port properties, go to “Port Settings” tab and click
“Advanced...”. Change port number to “COM1” and latency timer to “1”. Confirm configuration
via “OK” button.
3. Open C:\RHEINGOLD\EDIABAS\BIN\EDIABAS.INI with Notepad and check for “Interface = REMOTE and change to STD:OBD”.
4. In TCP settings confirm “Port = 6801”.
5. Close EDIABAS.INI Open ISTA and go to “Settings > Vehicle interface” and select “Ediabas default settings (ediabas.ini)”, then “OK”.
That is what I did, and everything is working perfectly. My COM was set to COM9. It needs to be changed to work correctly.
Appreciate the files!