02-02-2022, 10:32 PM
(02-02-2022, 05:05 PM)Mouse-ri Wrote: What should I change to start working with K+Dcan cable on E9x series?Next info as found on the web and used/tested my self:
Bocouse for now it does not work…Is there any tutorial?
1. Check in device manager that the K+DCAN driver is installed and check next settings:
- Set Com port to 9
- Set Latency timer to 1
2. Open C:\EDIABAS\BIN\EDIABAS.INI with Notepad and check for "Interface = STD:OBD".
3. Open C:\EDIABAS\BIN\OBD.INI with Notepad and check for "Port=Com9".
4. Run ISTA, go to Settings and select "Vehicle Interface" tab
- Select "Ediabas default settings (ediabas.ini)"
- Press "OK"