F30 NBT 5/6 lost Navigation after VO Coding

[kaya1923]

Dear bimmer friends,
I had to disable Sos and i therefore removed 6ac and 6ae from VO and recoded whole car.
While coding the NBT2 throw an error, the message was like NotExecutablr or similar.
NBT2 had blackscreen and i found out that the CAFD was removed, so i did revive NBT2 by SWEtoCAF and selected same iLevel as on car and reverted to original vo.
After that i found out that Nav is not working anymore.
On NBT i know how to generate Maps but for NBT2 i cant get FSC by 0x1B/0xDE or 0xDF.
I tried HUTool but there is no guide and i dont know if its correct what i am doing.
What options do i have, can i generate codes or can someone help me out get this one going.
Also, do i need to reinstall new map or will that one which is installed on the hdd work again?
Thanks

[kaya1923]

Hey everyone,

Unit is nbt evo id5 and maps are road map europe 2018-1/2 2018

I got the FSC Repair pack, but the A0 one gets rejected, do I have to reset the Unit completely with Tool32 and then try to install the FSCs again?
Is it normal that not all certificates are "upgradeable" in Esys FSC Extended?
For example A0 works to upgrade but gives FSCSStatus rejected when I check the status, but I also have some FSCs which are not possible to neither write/update nor "upgrade", I am speaking of the 3 buttons in esys.

Any Ideas or someone willing to help me?

[JSC]

buy feature installer code and patch headunit