2016 G11 i-step update

[b21playa]

Which ecu is it? Might be the gateway that is causing esys not to connect

Passenger seat message module. Connected fine before but had to change ip address to dhcp for Icom and can not remember where I found the details for esys enet cable settings. Zgw_search Shows nothing.

Ip: 169.254.1.1
Subnet: 255.255.0.0

I’m sure there were settings for gateway and dns, but as I said can’t find them

[TheNine90]

You can use itoolradar to look for the ip address

---

Or even use same ip shown in ISTA

[b21playa]

You can use itoolradar to look for the ip address

---

Or even use same ip shown in ISTA

nothing came up in itoolradar unfortunately

[TheNine90]

you can use enet cable. In esys you need to input ip address in icom ip

[b21playa]

Does anyone have the ip address / gateway etc for enet cable as I can not find the initial settings I used

EDIT - managed to get it finally connected via vin. Just need to read up how to flash via esys and sort out  on weekend when I have time to put the car on a power supply