2014 F10 VO code and inject CAFD Bimmer Utility

[dcummins41]

I just purchased Bimmer Utility(Windows Version) last week. 

They e-mailed me back and said. 

"Hello, yes it can VO code the new module and inject the cafd if needed"

Anyways, I changed out the RDC module as the old one was dead. I confirmed in Ista+

*Note* This is a used module off E-bay, same part#.

So, how do I do this using Bimmer Utility to vo code or inject CAFD file if needed?(I'm using Windows Version)

I'm also confused on why new E-sys I downloaded,  says use with Bimmer Utility? I downloaded and it runs by itself. 

Thanks,

Duane, MI

[adelin731]

I just purchased Bimmer Utility(Windows Version) last week. 

They e-mailed me back and said. 

"Hello, yes it can VO code the new module and inject the cafd if needed"

Anyways, I changed out the RDC module as the old one was dead. I confirmed in Ista+

*Note* This is a used module off E-bay, same part#.

So, how do I do this using Bimmer Utility to vo code or inject CAFD file if needed?(I'm using Windows Version)

I'm also confused on why new E-sys I downloaded,  says use with Bimmer Utility? I downloaded and it runs by itself. 

Thanks,

Duane, MI

Install the new module
open bimmerutility and connect the car
click on the 3 dots next to the module and inject cafd or whatever it says in there
then click on the 3 dots again and vo code
job done.

[mauro]

Hi Adelin, I have the same problem as Duane. However, I can't find any way to inject the new CAFD from BU (when clicking on the three dots, there is no option). Are you sure? Can you give me more specific instructions?