M340i Start-Stop coding faults

[Alexandru.k_24]

Hi guys,
After deactivating the start-stop system using the BimmerCode or BimmerUtility app (can't remember exactly wich app I used), the following fault message appeared on the Kombi (see attached image).
Before disabling the system, there were no faults. I deactivated the system because it was too invasive, and the start-stop deactivation button is also not present on the centre console. Is there a method or coding solution to get rid of this fault on Kombi? The car is a 2021 BMW M340i xDrive MHEV(285KW)
Thanks!
   

[mister]

esys default code module that you changed parametar and that is

[Alexandru.k_24]

esys default code module that you changed parametar and that is

Wouldn't this just reenable the start-stop system wich I just disabled throught coding? Indeed, the fault stored on KOMBI would dissapear, but the objective is to disable the start-stop system and have no faults.