06-13-2023, 09:37 PM
(06-13-2023, 04:02 AM)dcummins41 Wrote: I just purchased Bimmer Utility(Windows Version) last week.Install the new module
They e-mailed me back and said.
"Hello, yes it can VO code the new module and inject the cafd if needed"
Anyways, I changed out the RDC module as the old one was dead. I confirmed in Ista+
*Note* This is a used module off E-bay, same part#.
So, how do I do this using Bimmer Utility to vo code or inject CAFD file if needed?(I'm using Windows Version)
I'm also confused on why new E-sys I downloaded, says use with Bimmer Utility? I downloaded and it runs by itself.
Thanks,
Duane, MI
open bimmerutility and connect the car
click on the 3 dots next to the module and inject cafd or whatever it says in there
then click on the 3 dots again and vo code
job done.
ECU Remap Stage 1 / 2
Checksum Correction
PopCorn / Hard Cut Limiter
ECU Cloning
PopsBangs
Launch Control Activation
E85 Conversion
DPF / EGR / Adblue / NOX / Lambda and many more.