08-07-2020, 10:42 AM
In Case someone was looking so far i Know:
Switch mounted in the boot, Power wire goes to rear fuse box socket F121 in ZW2*10B
If you bought a harness its a green wire
From switch to camera you have video cable with grounding point along the way.
From switch to front of car you have one ground cable on the main loom,
The 3 pins go to quadlock
- Yellow - pin 21,
- White - pin 24
- Shield (clear) to pin 23
Orange and light green are can wires that go to same colour wires in IHKA connector
Finally, add 3GA to FA and code NBT and PDC.
Also, might need to run ista and calibrate camera.
Ill be doing this on tuesday will follow up.
Switch mounted in the boot, Power wire goes to rear fuse box socket F121 in ZW2*10B
If you bought a harness its a green wire
From switch to camera you have video cable with grounding point along the way.
From switch to front of car you have one ground cable on the main loom,
The 3 pins go to quadlock
- Yellow - pin 21,
- White - pin 24
- Shield (clear) to pin 23
Orange and light green are can wires that go to same colour wires in IHKA connector
Finally, add 3GA to FA and code NBT and PDC.
Also, might need to run ista and calibrate camera.
Ill be doing this on tuesday will follow up.