Issues with ICOM NEXT and ESYS

[DayvG]

Hi all,

I am having a tough time with making ESYS working with ICOM NEXT A.
I had a hard time reading this car even with ENET, so left the car locked for a couple of hours while i was doing something else.

Returned back to car now, and ENET worked straight away.
ICOM NEXT A  though even is reserved in itool , still ESYS says "no ZGW available".

i did pretty much everything i could find on the internet for this, but still no joy.

What am i missing?

P.S wireshark can see packets on lan with icom connected

That’s because the ICOM won’t see the ZGW/VIN readout in esys. You need to use iTool radar to read the ICOM IP address and enter it into the box in esys connection window that says ICOM/Ethernet. Keep the port the same, just put the IP where the 127.0.0.1 is.