No-Signal after retrofitting a reverse camera

[Anovo]

Hey guys,

I own a BMW f32 440i and unfortunately it only had the small display with the EntryNav. Shortly after I bought it, I bought a large display with an NBT Evo. The seller had also coded it so that it worked perfectly for me. So far so good.

Now I wanted to retrofit a reversing camera and code the whole thing via e-sys. As I have never worked with e-sys before, I relied on the instructions from the seller of the camera, which described the individual coding steps.

Basically, I should just add “3AG” as a code in the SALAPA element and encode the whole thing under SVT in HU_NBT2 and REM via the Encoding menu item.
It would have been nice if this had worked.
Now only “No-Signal” is displayed.
I've also tried restoring the backup, but it doesn't respond to that either, so I still only see “No signal”.
Do you have any idea what I should do differently now so that my radio and camera work?
Thank you in advance

[Aakashs03]

Hey Anovo, I am interested in retrofitting a reverse camera in my f36. How easy was the install? If you could can you share the steps?

[compusir123]

I think you also need to code FEM as well.

[JSC]

1. You must add 3AG to your FA, save and write new FA to the car. In your foto there is no 3AG in SALAPA element.
2. VO code HU, ICAM or TRSVC, FEM & REM