Steering column F30

[Siki78]

Hello! I try to exchange steering column (9253751 with 9253752) and add vibration and electronic on steering wheel.
But soon when I put steering column I receiver error rückhaltesystem störung fahrer and each button on steering wheel it‘s not working. I try steering column and there everything working normally except steering wheel there all stop to working. Should I do some coding like LIN_VARIANTE_SZL?
How can I encoded used SZL?
Thanks in advance

[XuLeTZ]

Hi,

I think you have to adapt it with ISTA after replacement.
I guess your indicators not working as they should as well.
Start ISTA -> Vehicle Management -> Control unit replacement and find it there. I replaced mine for the one with High beam assist and I had to tell ISTA to 'learn it' but I don`t remember the steps. Anyway, ISTA nowadays it's built for the lame excuse for "technicians" most dealers employ, and should be simple enough to figure out using basic common sense.

[Siki78]

What control steering wheel button? Electronic unit in steering szl or fem? I have just 2 pin in 12 pins connector power and ground and 4 wire a coming to szl

[Siki78]

Here all error what i get today

801C60 ZGM: No FlexRay initialisation -1 yes Information
030410 Multifunction steering wheel (MFL): Missing LIN slave 134249 yes
030490 Steering wheel electronics module (LRE): Missing LIN slave 134249 yes
8044B0 Shift paddles: Short circuit to B+ 134249 yes
930904 Driver's airbag, interval stage 1: Resistance too high 134249 yes
420665 Shift paddle: (shift paddle operation, 0x207) signal invalid 134249 yes Information
D01734 Message (cruise control operation, 233.1.2) not current, receiver ICM,transmitter FEM / SZL / BDC-ZGM134249 yes Information
D01736 Signal (cruise control operation, 233.1.2) invalid, transmitter FEM /SZL / BDC-ZGM134249 No Information
D01484 Message (steering wheel vibration status, 268.0.4) not current,received by ICM, transmitted by FEM / SZL / BDC-ZGM134249 yes Information
D01903 Signal (steering wheel vibration, 268.0.4) invalid, transmitted by FEM /SZL / BDC-ZGM

[Clauss_acs]

SZL (Switch unit steering column module) fault.
https://www.youtube.com/watch?v=vQFp-RT1UBc

[ek1978]

SZL (Switch unit steering column module) fault.
https://www.youtube.com/watch?v=vQFp-RT1UBc

your video adds zero value/Benefit to anyone on this forum or any other forums.

[GopherTee]

SZL (Switch unit steering column module) fault.
https://www.youtube.com/watch?v=vQFp-RT1UBc

your video adds zero value/Benefit to anyone on this forum or any other forums.

Much like your comment.  If you don't know leaver A, then leaver B.

[ek1978]

SZL (Switch unit steering column module) fault.
https://www.youtube.com/watch?v=vQFp-RT1UBc

your video adds zero value/Benefit to anyone on this forum or any other forums.

Much like your comment.  If you don't know leaver A, then leaver B.

hahahaha , you are very funny