HU_NBT wrong bus error when writing SVT for an unrelated change

[bradsm87]

I'm preparing to permanently remove my TCB. I removed the 6AC and 6AE options and added the HO-Wort "TELD" on the FA and wrote the FA to the VCM.

I read the SVT from the VCM, removed TCB, saved it then opened the file in the VCM section. When I went to write SVT, it gave the error attached. I did not proceed.

I then did a "Read (ECU)" and compared the files of the SVT read from the VCM and the "Read (ECU)" (I'll call it "actual") one and found a difference:

SVT from VCM: <ecuBusConnectionInfo busType="ETHERNET" busID="15"/>

SVT actual: <ecuBusConnectionInfo busType="ETHERNET_63" busID="22"/>

Should I:

1) Ignore the error and write the VCM based on the SVT taken from the VCM.

2) Use the SVT data from the "Read (ECU)" to write to the VCM.

[TheNine90]

Delete the ecu from the svt and write to vcm. Ignore the error

[bradsm87]

Delete the ecu from the svt and write to vcm. Ignore the error

After reading more since I posted the thread, it seems that NBT probably should list ETHERNET_63 busID 22 rather than ETHERNET busID 15. What puzzles me is why Ethernet busID 15 was ever in the SVT in the first place for NBT.

[bradsm87]

I ended up going for an option 3 haha.

I edited the file from the VCM and changed the HU_NBT to busType="ETHERNET_63" busID="22". No error. No issues.