Issues with ICOM NEXT and ESYS

[4evermetalhead]

Hi all,

I am having a tough time with making ESYS working with ICOM NEXT A.
I had a hard time reading this car even with ENET, so left the car locked for a couple of hours while i was doing something else.

Returned back to car now, and ENET worked straight away.
ICOM NEXT A  though even is reserved in itool , still ESYS says "no ZGW available".

i did pretty much everything i could find on the internet for this, but still no joy.

What am i missing?

P.S wireshark can see packets on lan with icom connected

That’s because the ICOM won’t see the ZGW/VIN readout in esys. You need to use iTool radar to read the ICOM IP address and enter it into the box in esys connection window that says ICOM/Ethernet. Keep the port the same, just put the IP where the 127.0.0.1 is.

Thanks for the reply mate.
Yes, correct. I managed to figure it out.

Though now i am facing another issue.
I get this:
No FP could be generated from FA "". [C002]
Not all elements of the FA were found in the FA2FP: HO-Word FLCN
[72]
when activating FA.
Refers to headlight sensitivity, which i know has been changed before to 100%, though i dont know if that causes the error or not.

I am now downloading PSzData 4.25.12, hoping this will help.
Though i think this is unrelated to the issue.