Hi everyone, maybe I'm a bit slow on the uptake 
, but I need your help: I have the following setup: ISTA 4.56.30 with 4.56.35 programming data. I can read diagnostic data and the current voltage at the devices, i can programm ECUs, but I can't write service data because ISTA isn't detecting the voltage at terminals KL15 and KL30 via the enetcable. Is there a solution or workaround to fix this problem without having to buy an ICOM?
In older versions, you could disable voltage control via registry entries or a power supply software tool.
Need your help, please!
, but I need your help: I have the following setup: ISTA 4.56.30 with 4.56.35 programming data. I can read diagnostic data and the current voltage at the devices, i can programm ECUs, but I can't write service data because ISTA isn't detecting the voltage at terminals KL15 and KL30 via the enetcable. Is there a solution or workaround to fix this problem without having to buy an ICOM?In older versions, you could disable voltage control via registry entries or a power supply software tool.
Need your help, please!
![[-]](https://www.bimmerscene.com/images/collapse.png)