Hello from Poland, Im David

Hi from U.S. where can I get a 2021 nav update from?

Hi guys,

Really need some help here.   New to the forum.   I see lots of you are experts here. 
I have a 2011 F10 535i,  car was running fine without any fault codes but recently  I use the xHP Flashtool to code the transmission,   after I coded it It shows the "Chassis Stabilization Failure".  This error will disable my sport / sport+ mode.   I can only drive normal mode.     Some people say it could be the wheel speed sensor, but in ÎŜ†Ä software I don't see any option to check that.   Also i think my car is little too old with the firmware/software.   ÎŜ†Ä software update also grayed out.    Is there way to update my car's module firmware/software.

Even though delete the fault code.   Within 1 min, the Chassis stabilization malfunction error will come back.    

I just want to get rid of that error and able to use sport/sport+ mode.

Any help will be great.

Thanks
Ced

I am from Romania and I drive a 5 F11 series
and I want to learn how to read and code my car.
thanks for the accept.

Hi guys, F87 here. Does anyone know how to code the rear ECU so that my rear PDC stops once I take the car out of reverse? Thank you so much!

I have been coding my F30 NBTevo_W id6   with Bimmercode in Expert mode. HU_NBT - (Expert Mode) - APPLE CARPLAY_FULLSCREEN - aktiv. but it turns out that 1/3 of the screen is empty. Is there any proper code for BimmerCode? Thank you. (I'm NEW HERE)

Attached Files

Thumbnail(s)
   

Hello everyone I have a question, I have an E90 N52B30 258km, msv70, will I be able to upload winkfp soft from the 272km version?


 regards

Hi guys,
My name is David.
I drive Mini F56S ))
Want to improve my Mini - swap NBT to EVO with touchscreen and CarPlay and the most important part is to do it myself  (including physical swap and coding). 
Happy to be here)

Does anyone have any ideas on a version of ÏÑÞÀ that works well with the N63 engine?
Or how to configure it correctly?





 INPA_Fxx_v.2 which seems to have installed correctly.
However, the screen with the adaptations, F5 digital/analog only has "F1" visible, others greyed-out.

Likewise, I would like to attempt to control some other motors on the vehicle, maybe a coolant flush, and have already spent time becoming proficient on the 545i, N62 engine.

Have version of ÎŜ†Ä+ 4.31 and doesn't seem to have the functionality of ÏÑÞÀ.


Does anyone know how or even if you can activate EXPERT MODE, or is this only a ÏÑÞÀ/P feature.

Regards